CLAQSP(3)      LAPACK routine of NEC Numeric Library Collection      CLAQSP(3)



NAME
       CLAQSP

SYNOPSIS
       SUBROUTINE CLAQSP (UPLO, N, AP, S, SCOND, AMAX, EQUED)



PURPOSE
            CLAQSP equilibrates a symmetric matrix A using the scaling factors
            in the vector S.




ARGUMENTS
           UPLO      (input)
                     UPLO is CHARACTER*1
                     Specifies whether the upper or lower triangular part of the
                     symmetric matrix A is stored.
                     = 'U':  Upper triangular
                     = 'L':  Lower triangular

           N         (input)
                     N is INTEGER
                     The order of the matrix A.  N >= 0.

           AP        (input/output)
                     AP is COMPLEX array, dimension (N*(N+1)/2)
                     On entry, the upper or lower triangle of the symmetric matrix
                     A, packed columnwise in a linear array.  The j-th column of A
                     is stored in the array AP as follows:
                     if UPLO = 'U', AP(i + (j-1)*j/2) = A(i,j) for 1<=i<=j;
                     if UPLO = 'L', AP(i + (j-1)*(2n-j)/2) = A(i,j) for j<=i<=n.

                     On exit, the equilibrated matrix:  diag(S) * A * diag(S), in
                     the same storage format as A.

           S         (input)
                     S is REAL array, dimension (N)
                     The scale factors for A.

           SCOND     (input)
                     SCOND is REAL
                     Ratio of the smallest S(i) to the largest S(i).

           AMAX      (input)
                     AMAX is REAL
                     Absolute value of largest matrix entry.

           EQUED     (output)
                     EQUED is CHARACTER*1
                     Specifies whether or not equilibration was done.
                     = 'N':  No equilibration.
                     = 'Y':  Equilibration was done, i.e., A has been replaced by
                             diag(S) * A * diag(S).



       Internal Parameters:


             THRESH is a threshold value used to decide if scaling should be done
             based on the ratio of the scaling factors.  If SCOND < THRESH,
             scaling is done.

             LARGE and SMALL are threshold values used to decide if scaling should
             be done based on the absolute size of the largest matrix element.
             If AMAX > LARGE or AMAX < SMALL, scaling is done.



LAPACK routine                  31 October 2017                      CLAQSP(3)